TEMES 1.0

Figure 2-57b: Parameter tree node XCP/CCP editor: ECU.

 

Name: The name is a unique and non-empty name of the ECU.

 

Protocol: The protocol is either XCP or CCP.

 

CAN Identifiers: The identifiers are specified in hexadecimal. When the XTD checkbox is checked, the identifier is treated as an extended 29-bit-identifier, otherwise as a standard 11-bit-identifier. When the FD checkbox is checked, the identifier specifies a CAN-FD-message. When the BRS checkbox is checked, the identifier specifies a message with bit rate switching (which is only supported by CAN FD).

 

ECU uses big Endian: This checkbox is used to define the byte order which is used internally by the ECU. Note that this value is also provided by the ECU during the beginning of the XCP communication.

 

Enforce polling: This checkbox is used to use polling instead of DAQ messages. The polling method is simpler but also slower. If a definition with DAQ lists does not show the desired signal, please try polling instead, to see whether a valid signal is available.