TEMES 1.0

If the device does not show an initial text onto its display while turning the switch from off to on position, then please verify whether the device is connected to a power source. The RS232 connection does not supply the device with current.

If the SICO2 does not communicate with TEMES then the following procedure might be helpful:

•Turn SICO2 off

•Bridge pin 2 and pin 3 (= two lower pins) of the connector LOGIC I/O, e. g. with a straightened electrically conducting paper clip

•Turn SICO2 on (the display is invalid due to a blocked communication with the LCD)

•Wait 5 seconds

•Remove the bridge (e. g. remove the paper clip)

•Program the SICO2 with TEMES