TEMES 1.0

Figure 5-1: Unscrew the four M2.5 screws from the lid and the two M2.5 screws from the parallel interface.

Figure 5-2: Turn the lid to the top. (Pay attention that the LED is adjusted correctly, and that the wires don't occupy the space for the MCU when closing the lid).

Figure 5-3: Lift the right side of the DL16CAN until the memory card can be seen.

Figure 5-4: Remove the card. The card can be levered with a screwdriver (by using the notches).

Battery replacement:

•Recommended Batteries:
PAYOVAC     BR2325
PANASONIC BR2325
PANASONIC CR2025

•Setting the write-protect switch: This switch is similar to the write-protect switch on the floppy disk. Write is inhibited when the switch is toggled to the write-protect position, and vice versa otherwise.

•Unlock the battery cover: Push the switch left and pull out using a pen.

•Take off the cover with the old battery.

•Insert a new (recommended) battery into the card.

•Put the battery cover on and lock-up.

•Note: Once the battery is removed from the card, it must be replaced within 20 minutes, or the data will be lost.