TEMES 1.0

Figure 2-27: Parameter tree node CAN.

 

Library: Drop-down list box with all known CAN descriptions (= .CAN files which are in the CAN-subfolder of the TEMES data folder which is usually "documents\TEMES\CAN"). The Signals list box is filled with the corresponding CAN messages and signals when a new library is selected.

 

Signals: Supported CAN messages and CAN signals (below CAN messages). When a CAN signal is selected, also the Add input/output buttons are enabled. Note that CAN signals are suppressed if they are not supported by the corresponding device (meaning if the signal has a data length of 32, then it will only be shown in case of a SICOLOG/SICO3/USBDL1 device).

 

Add Input: The add input button generates a new input in the parameter tree (as long as the CAN signal has not already an output tree node).

 

Add Output: The add output button generates a new output in the parameter tree (as long as the CAN signal has not already an input tree node).

 

Library Refresh: The CAN definition is overtaken as soon as possible from the CAN library (at the moment when a parameter tree node is generated). However, to change the CAN settings of the TEMES document according to a new/changed CAN description, this button must be pressed: The CAN identifier of the same CAN message names are changed, and the CAN message names of the same CAN message identifiers are changed. CAN signals are treated the same way (with start bit and bit length instead of the id respectively). CAN signals which are not mappable are removed in the TEMES document.