Kits for CTS7F

CTS7F Kits

CTS7F works for motorbikes with a transistor ignition. Motorbikes with a C.D.I. system are not supported for technical reasons by CTS7F. For Suzuki bikes, an SPU (see below) is required to prevent the display of an error code. In some cases this error code can also be omitted by reprogramming the ECU. In this case, only the standard kit with force sensor is required.

CTS7F Kit with Force Sensor (Universal)

This universal kit works for most motorbikes with an accessible gearshift linkage and which are not from Suzuki. It consists of figure 1 and figure 2. The force sensor is available in four different configurations: As a stretch sensor or as a pressure sensor, and either with a right-handed thread (= standard) or a left-handed thread of the magnet plate. The standard force sensor triggers only for upshifting in one (user adjustable) direction.

CTS electronic box with hook and loop fastener and connection cable

Figure 1: CTS electronic box with hook and loop fastener and connection cable.

Force sensor, position sensor, position sensor holder and magnet lever with 90° block and screw

Figure 2: Force sensor, position sensor, position sensor holder and magnet lever with 90° block and screw.

CTS7F Kit with Pin Sensor (Universal)

This universal kit works for most motorbikes without an accessible gearshift linkage and which are not from Suzuki. It consists of figure 3 and figure 4.

CTS electronic box with hook and loop fastener and connection cable

Figure 3: CTS electronic box with hook and loop fastener and connection cable.

Pin sensor, position sensor, position sensor holder and magnet lever with 90° block and screw

Figure 4: Pin sensor, position sensor, position sensor holder and magnet lever with 90° block and screw.

CTS7F Kit for Suzuki Motorbikes (Universal)

This universal kit works for most Suzuki motorbikes with an accessible gearshift linkage. It consists of figure 5 and figure 6. The force sensor is available in four different configurations: As a stretch sensor or as a pressure sensor, and either with a right-handed thread (= standard) or a left-handed thread of the magnet plate. The standard force sensor triggers only for upshifting in one (user adjustable) direction.

CTS electronic box with hook and loop fastener, heat shrink tubings, SPU and harness

Figure 5: CTS electronic box with hook and loop fastener, heat shrink tubings, SPU and harness.

Force sensor, position sensor, position sensor holder and magnet lever with 90° block and screw

Figure 6: Force sensor, position sensor, position sensor holder and magnet lever with 90° block and screw.

Option: Gear Shift Flash for CTS7F

Gear shift flash lamp with connection cable

Figure 7: Gear shift flash lamp for CTS7F with connection cable.

CTS7F Kits for Specific Motorbike Models